Emergency Lights

Nylube Products Company, LLC.Home Online Catalog Service Bulletins MSDS's FAQ Contact Nylube

Emergency Lights

When Power Fails...Assure Instant Lighting and Alarm with Nylube's

Elevator Emergency Light and Alarm Systems

The Industry Standard for over 25 years for some very good reasons:

Full line of models for new cabs and modernization - Designed to meet every installation condition.
Exceeds A17.1 Safety Code - even with lights and alarm operating simultaneously.
Up to 8 hours lighting - full capacity restored in 2 hours for every hour of discharge.
Easily installed, self-contained units - rugged tamper-resistant construction.
No exposed delicate circuits or components to damage, nickel cadmium battery and solid state electronics.
220 Volt, 50-60 Hz models available.
Complete inventory of replacement parts stocked for convenient field servicing.
Proven reliable...years of maintenance-free field operation- justifying the longest warranty on electronics and batteries in our industry!

Models Available

EL-SS (#1100) Surface mounts above or near car station. Stainless #4 finish standard. Also available in Muntz #4 finish (EL-MTZ, #1105) and Stainless #8 Mirror finish. CSA version available (EL-CSA, #1110).

EL-FML (#1116) Lower cost surface mount unit for ceiling. Generally used on translucent drop ceilings (eggcrates) face down shining through. Entire face plate acts as as lens.

ELW-2 (Slimline) (#1111 with Bell, #1121 w/o Bell) Car top power supply and remote slimline fixture. Available with high performance ELB-6-U 6 volt bell. CSA version available with attached interrupter bell (ELW-2INT/CSA #1111/1112).

ELW-3 (Car Station) (#1111/1122 with Bell, #1122 w/o Bell) Car top power supply and remote car station fixture. Fixture requires pre-existing hole in car operating panel. Available with high performance ELB-6-U 6 volt bell.

EL-KMW (#1101) Car station power supply. Plate unit meant to be located inside operating panel. Common replacement for Westinghouse/Schindler units. Does not include fixture. With optional car station fixture order EL-KMW-3 (#1101/1120).

EL-NEMA 4 (#1114) Explosion resistant emergency light. Complies with NEMA 4 requirements. Usually must be special ordered.

NYPS-3 (#1103) Bell or intercom power supply. Plate unit does not include box.

NYLV-7 (#1119) Nylite Emergency Light. Powers two of the Nylite low voltage ceiling lights at a reduced light level.

Special Veterans Administration and GSA Units

EL425W-2 (#1117 with Bell, #1118 w/o Bell) Similar in appearance to ELW-2, uses a slimline fixture but provides 1.0 footcandle as opposed to standard 0.2 footcandle.

EL-GSA (#1113) GSA model with EL remote (same stainless fixture used in EL-SS). Also available with #4 Muntz remote.

Util-Lights - Combination Utility Box/Emergency Light & Bell

Emergency Light

Car top power supply with remote surface mounting slimline (ELW-2UTIL) or car station fixture (ELW-3UTIL).
6 Volt DC alarm bell (CSA interrupter models available).
Up to 6 hours lighting and alarm - full capacity restored in two hours for every hour of emergency use.

Utility Box

Mechanic's worklight with grounded metal lamp guard (meets OSHA requirement #1926.401)
Up to 100 watt incandescent bulb with protective coating to prevent shattering (Recommended Option - additional cost)
Two grounded 125 volt outlets with Ground Fault Circuit Interrupter for power tool and test equipment connection.

Service Bulletin #3 (Electrical Troubleshooting) | Service Bulletin #12 (Warranty Procedure)

2299 Star Court • Rochester Hills, MI 48309 • Tel: 248.852.6500 • Fax: 248.852.6505